|
![]() |
#24 | |
I barely grok the obvious
|
![]() Quote:
![]() Oscar steam gets easy with practice. I recall removing cooked-on spatters of boiled scalded milk from the machine, floor, counter, clothes, walls, stove, eyeglasses and ceiling. With a small pitcher for one drink I maybe use half the pressure to stretch it out to microfoam over 15-seconds; to slow time down start with steel pitcher/milk chilled, direct from fridge or freezer. If you don't bother with a thermometer figure when the pitcher becomes too hot to hold barehanded you've hit about 130*F - time is getting short when you can't barehand the pitcher, right? And your nose tells the rest. I pull an electrical lead on mine when descaling and, after soaking, pump what little crud there is out thru the wand. I have well water and a 5-mic filter - tastes great and doesn't leave much in the boiler during 1/annual descale. DO remove the tip before pumping the boiler out that way. DO change the dispersion screen screw out with a phillips, torx or (preferably) allen drive machine screw and DEFINITELY clean the screen and brass heat sink regularly or you will have bitter/skunky espresso. Treat the dispersion screw threads with a light swipe of Vaseline before reinstalling it and only loosen it when the machine is cold. Backflush slowly/regularly with a spoonful or Urnex in the blank basket.
__________________
"I hope you had the time of your life." Last edited by Mister Moo; 07-20-2009 at 11:50 AM. |
|
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|