|
10-14-2008, 11:41 PM | #1 |
Back from the dead
|
Quick pipe lighter mod
I came apon this when i found myself toasting my fingers instead of lighting my pipe.
step one- get your regular zippo. step two- remove the insert and clamp to a table or drill press stand step three- Use a 1/4 inch drill bit to drill a small hole in the flame guard. (go very slow) step four- Use increasingly larger bits intill you get to the size hole you would like. You can drill both sides if you want but i only did one side as i am right handed and light my pipe that way. Also If you drill borth sides it may not be symetrical or have the wind resistance zippos are known for. (today i lit up in 10+ MPH winds no prob) step five- re assemble the zippo and light the lighter... wait a few secconds to let chemicals dissapate the hold the lighter perpendicular to the bowl of your pipe. While you are puffing the flame will take a right angle and go straight into your bowl. |